BMW K1200/1300 S/R/GT (GT 2006+) and all K1600GT/GTL Fuel Line Connector kit 2pc

Description

Fits all BMW K1200, 1300S, 1300R, 1300GT (GT from 2006+) and all K1600GT, and K1600 GTL.
These are the parts BMW should have supplied in the first place!
This eBay listing is for (
2)
*
UPGRADED
*
CHROME
-
PLATED,
SOLID
BRASS
FUEL
COUPLERS
with
STAINLESS
STEEL
valve
sprin
g,
pin
and
latch
, and features
VITON o-rings
(Viton is much longer lasting than the OEM rubber o-rings which break down from fuel & oil).
All OEM male couplers do not have the added internal safety shut-off valve that these have! These internal stainless steel safety valves will close off the flow of fuel when the couplers are disconnected. When connected, these internal valves will be pushed open, allowing fuel to flow across again.
These couplers are made from the same manufacturer "CPC" which made the original OEM plastic connector.
The male coupler is barbed for 1/4" (6mm) ID fuel hose and the female threaded coupler is 3/8" NPT.
The original plastic fuel line couplers are infamous to snapping off when moving the gas tank with the fuel lines attached
! Y
ou will ride and sleep much better knowing that you have replaced those horrible plastic couplers with metal ones using the
proper
VITON o-rings
.
Alternatively, you could go to the dealer and spend the + on getting another OEM plastic coupler, but they will snap again and again and eventually leak through the rubber o-ring unlike these that will last a lifetime!
You will need a small hose clamps to secure the male coupler to their fuel line.
For any questions at all, please message me. I have used these myself and love them. I recommend putting RTV sealant on the threads to seal them when installing, which also helps prevent the possibility of over-torquing the coupler in fear of a leak.
If you are having trouble removing a broken plastic coupler, trying using an "easy-out/screw extractor". You may have to cut down the screw extractor's tip to fit snugly, as the threaded hole on the fuel tank may be too shallow if the screw extractor is too small/long.
The pictures above show an original OEM plastic connector that this metal one will replace. There is also a picture of a typical situation when replacing one of the OEM plastic couplers. The tip on the screw extractor shown in the picture was cut off to fit far enough into the hole for gripping the inside of the broken connector.
My couplers directly replace the original plastic fuel line connector
(A.K.A quick connect / disconnect, dry break, coupler, coupling ) for the models & years listed here.
(If any of my information below appears to be incorrect, or you purchase this item for a model listed below and it doesn't fit, please contact me so I can fix my list. I offer full refund and return shipping for this
scenario
).
Thank You & Have Fun!